Mti-wireless-edge MT-900007 User Manual download pdf

Installation Instructions for MT-900007

Rev V0, Oct 18

2004

1. Assemble your electronics inside the MT-900007. If you are using an adapting plate,

assemble the electronics on the adapting plate and install it inside the enclosure.

2. Make sure the RJ45 jack is on the side facing the M20 threaded hole as shown in Fig-1.

3. Attach the antenna and the mounting kit to the MT-900007 following the relevant assembly

instructions provided with the MT-900007 and the mounting kit MT-120018/A.

4. Seal the Seal-Test Hole and screw the GND terminal following the relevant assembly

instructions provided with the MT-900007.

Figure 1: View on the M20 Threaded Hole and the RJ45 Jack Inside

5. Insert the CAT5 cable through the M20 water-tight gland provided with the MT-900007 kit

as shown in Fig-2

Figure 2: CAT5 Cable & M20 Water Tight Gland

1 2

Installation Instructions for MT-900007 Rev V0, Oct 18th 2004 1. Assemble your electronics inside the MT-900007. If you are using an adapti

Page 2

Installation Instructions for MT-900007 2 6. Crimp the RJ45 connector to the CAT5 cable and click it into the RJ45 jack as shown in Fig-3 Figure

No comments

Mti-wireless-edge MT-900007 User Manual